Honda ACCORD HYBRID 2005 Service Manual page 668

EVAP System
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
2 1 . Disconnect the v a c u u m hose (A) f r o m the EVAP
canister purge valve (B), and connect a T-fitting (C)
f r o m the v a c u u m gauge and the v a c u u m p u m p /
gauge, 0—30 in.Hg, to the hose as s h o w n .
22. Do the EVAP CVS ON in the INSPECTION MENU
w i t h the HDS.
23. S l o w l y apply about 2 kPa (0.6 in.Hg, 15 m m H g ) of
v a c u u m to the hose.
24. Reconnect all hoses.
25. Turn the ignition switch ON (II).
26. Reset the PCM w i t h the HDS.
27. Do the PCM idle learn procedure (see page 11-340).
28. Do the EVAP FUNCTION TEST in the INSPECTION
MENU w i t h the HDS.
Is the result OK?
YES—Troubleshooting is c o m p l e t e . •
NO—Check for poor connections or loose terminals
at the FTP sensor, the EVAP canister purge valve, or
the EVAP canister vent shut valve and the PCM,
then go to step 1.
Does the hose hold vacuum?
YES—Check for blockage at the EVAP canister port,
then go to step 24.
NO—Replace the EVAP canister vent shut valve
(see page 11-437), then go to step 24.
11-428