Honda ACCORD HYBRID 2005 Service Manual page 1088

Automatic Transmission
T r a n s m i s s i o n I n s t a l l a t i o n ( c o n t ' d )
48. Install the starter (A) w i t h a new gasket (B) on the
t o r q u e converter housing.
49. Connect the solenoid harness connector (A).
50. Install the starter cables (B), and install the harness
c l a m p (C) on the clamp bracket (D).
5 1 . Install the transmission g r o u n d cable (E).
52. Secure the radiator hose c l a m p (F) w i t h the bolt.
53. Connect the steering joint (see page 17-11).
54. Refill the transmission w i t h ATF (see step 5 on page
14-231).
55. Install the battery base.
56. Install the intake air duct and air cleaner housing.
57. Install the battery tray, battery, and battery hold-
d o w n bracket, then connect the battery terminals.
58. Install the splash shield.
59. Reinstall the hood support strut to the upper
location on right side of the hood.
60. Do the m o t o r rotor position calibration (see page
12-6).
6 1 . Set the parking brake. Start the engine, and shift
the transmission t h r o u g h all positions three times.
Check the shift lever operation, A/T gear position
indicator operation, and shift cable adjustment.
62. Check and adjust the front w h e e l alignment
(see page 18-7).
63. Start the engine in the P or N position, and w a r m it
up to normal operating temperature (the radiator
fan comes on).
64. Turn off the engine, and check the ATF level
(see page 14-230).
65. Perform the road test (see page 14-199).
66. Enter the radio code (navigation code), then enter
the customer's audio presets, and set the clock.
67. Do the power w i n d o w control unit reset procedure
(see page 22-200).
68. If the IMA battery level gauge (BAT) displays no
segments, start the engine in the P or N position,
and hold it between 3,500 and 4,000 r p m w i t h no
load until the BAT displays at least three segments.
14-252