Honda ACCORD HYBRID 2005 Service Manual page 923

17. M o n i t o r the OBD status for P0706 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a fail?
YES—Go to step 18.
NO—Intermittent failure, the system is OK at this
t i m e . Check for poor connections or loose terminals
at the transmission range switch and the PCM. If
the tester indicates NOT COMPLETE, return to step
15 and r e c h e c k . •
18. Turn the ignition switch OFF.
19. Disconnect the transmission range switch
connector.
20. Check for continuity between transmission range
switch connector terminal No. 5 and body g r o u n d .
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
GND (BLK)
W i r e side of female t e r m i n a l s
Is there continuity?
Y E S - G o t o step 2 1 .
NO—Repair an open in the w i r e between the
transmission range switch and g r o u n d (G101,
G102), or repair a poor ground (G101, G102), then
go to step 26.
2 1 . Turn the ignition switch ON (II).
22. Measure the voltage between transmission range
switch connector terminals No. 5 and No. 6.
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
c
1 2
3
4 5
r
6
7 8 9 1 0
ATP FWD
GND (BLK)
W i r e side of female t e r m i n a l s
Is there voltage?
Y E S — G o t o step 23.
NO—Repair an open in the w i r e between the
transmission range switch and PCM connector
terminal C19, then go to step 26.
23. Measure the voltage between transmission range
switch connector terminals No. 2 and No. 5.
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
ATP D
( Y E L / G R N )
GND (BLK)
W i r e side of female t e r m i n a l s
Is there voltage?
Y E S — G o t o step 24.
NO—Repair an open in the wire between the
transmission range switch and PCM connector
terminal C10, then go to step 26.
(cont'd)
14-87