Honda ACCORD HYBRID 2005 Service Manual page 1108

A/T Gear Position Indicator
T r a n s m i s s i o n R a n g e S w i t c h R e p l a c e m e n t ( c o n t ' d )
13. Set the selector control shaft to the N position by
t u r n i n g the selector control shaft w i t h a 6.0 m m
w r e n c h .
14. Install the transmission range switch (A) gently
over the selector control shaft (B), and install the
bolts loosely.
15. Install the new lock washer (A) over the selector
control shaft (B) while aligning the projection (C) of
the lock washer w i t h the N positioning line (D) on
the transmission range switch (E), and install the
locknut (F).
6 x 1.0 mm
F
12 N m
(1.2 k g f m
8.7 Ibf-ft)
16. Push the locknut against the transmission housing
to seat the transmission range switch into the
selector control shaft, and tighten the locknut to
12 N m (1.2 kgf-m, 8.7 Ibf-ft) w h i l e holding the
selector control shaft w i t h a 6.0 m m w r e n c h , then
bend the lock tabs against the locknut.
17. Tighten the bolts to 12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
securing the transmission range switch.
14-272