Honda ACCORD HYBRID 2005 Service Manual page 1263

DTC 5: Open In The Motor Wire Harness
1. Turn the ignition switch ON (II).
2. Clear the DTC w i t h the HDS.
3. Start the engine.
4. Turn the steering wheel to right or left, and w a i t
10 seconds or more.
Does the EPS indicator come on?
Y E S — G o t o step 5.
NO—The system is OK at this time. •
5. Stop the engine, and verify the DTC.
Is DTC 5 indicated?
Y E S — G o t o step 6.
NO—Perform the appropriate troubleshooting for
the DTC i n d i c a t e d . •
6. Turn the ignition switch OFF.
7. Check the No. 22 (EPS) (70 A) fuse in the under-
hood fuse/relay box.
Is the fuse OK ?
Y E S — G o t o step 8.
NO—Replace the fuse and recheck. •
8. Disconnect EPS control unit connector B (2P).
9. Measure the voltage between EPS control unit
connector B (2P) t e r m i n a l No. 1 and body ground.
E P S C O N T R O L UNIT C O N N E C T O R B (2P)
Wire side of female t e r m i n a l s
Is there battery voltage?
Y E S — G o t o step 10.
NO—Repair open in the w i r e between the No. 22
(EPS) (70 A) fuse and EPS control unit. •
10. Check for continuity between EPS control unit
connector B (2P) terminal No. 2 and body g r o u n d .
E P S C O N T R O L UNIT C O N N E C T O R B (2P)
Wire side of female t e r m i n a l s
Is there continuity?
Y E S — G o t o step 11.
NO—Repair open in the w i r e between the EPS
control unit and the body g r o u n d (G651). •
11. Disconnect EPS control unit connector A (2P) and
the motor 2P connector.
(cont'd)
17-31