Honda ACCORD HYBRID 2005 Service Manual page 1052

Automatic Transmission
A / T C l u t c h P r e s s u r e C o n t r o l S o l e n o i d V a l v e A a n d B R e p l a c e m e n t
1. Get the customer's radio anti-theft code (navigation
code), and w r i t e d o w n the customer's audio
presets.
2. Disconnect the negative t e r m i n a l f r o m the battery,
then disconnect the positive t e r m i n a l .
3. Remove the battery h o l d - d o w n bracket, and
remove the battery and battery tray.
4. Remove the intake air duct and air cleaner housing.
5. Remove the battery base.
6. Remove the nuts securing the shift cable bracket
(A).
7. Remove the spring clip/washer (B) and the control
pin (C), then separate the shift cable end (D) f r o m
the control lever (E).
8. Disconnect the connectors f r o m the A/T clutch
pressure control solenoid valve A, B, solenoid
harness, transmission range s w i t c h , ATF
temperature sensor, o u t p u t shaft (countershaft)
speed sensor, input shaft (mainshaft) speed sensor,
3rd clutch transmission f l u i d pressure switch, and
4th clutch transmission fluid pressure switch.
9. Remove the bolt securing the harness cover (A).
6 x 1.0 m m
12 N-m
(1.2 k g f m ,
8.7 Ibfft)
10. Remove the A/T clutch pressure control solenoid
valve A and B, ATF pipes (C), and gasket (D).
6 x 1.0 m m
12 N-m
(1.2 kgf m, 8.7 Ibfft)
11. Check the fluid passage of the A/T clutch pressure
control solenoid valve for dust and dirt, and clean
the passage if necessary.
14-216