Honda ACCORD HYBRID 2005 Service Manual page 1471

21. Use suction cups to hold the rear w i n d o w over the
opening, align it w i t h the alignment marks y o u
made in step 15, and set it d o w n on the adhesive.
Lightly push on the rear w i n d o w until its edges are
fully seated on the adhesive all the w a y around. Do
not open or close the doors until the adhesive is dry.
22. Scrape or w i p e the excess adhesive off w i t h a putty
knife or t o w e l . To remove adhesive f r o m a painted
surface or the rear w i n d o w , use a soft shop towel
dampened w i t h alcohol.
23. Let the adhesive dry for at least 1 hour, then spray
water over the rear w i n d o w and check for leaks.
Mark the leaking areas, let the rear w i n d o w dry,
then seal w i t h sealant. Let the vehicle stand for at
least 4 hours after rear w i n d o w installation. If the
vehicle has to be used w i t h i n the first 4 hours, it
must be driven slowly.
24. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the f o l l o w i n g
things for 2 to 3 days:
• Slam the doors w i t h all the w i n d o w s rolled up.
• Twist the body excessively (such as w h e n going
in and out of driveways at an angle or driving
over r o u g h , uneven roads).