Honda ACCORD HYBRID 2005 Service Manual page 557

8. Check for continuity between engine mount control
unit 20P connector terminal No. 8 and body ground.
ENGINE MOUNT CONTROL UNIT 20P CONNECTOR
S O L R L Y
(BRN)
1 2 3 4
i — i
5 6
A
8 9
10 11 12
/
14 15 16 17 A
/
20
Wire side of female terminals
Is there continuity?
10. Turn the ignition switch ON (II).
11. Reset the PCM w i t h the HDS.
12. Do the PCM idle learn procedure (see page 11-340).
13. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
YES—If DTC P16C5 is indicated, check for poor
connections or loose terminals at the engine m o u n t
control unit and the active control engine m o u n t
(ACM) control relay, then go to step 1. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTCs troubleshooting.
NO—Troubleshooting is c o m p l e t e . •
YES—Repair short in the wire between the engine
mount control unit (No. 8) and the active control
engine m o u n t (ACM) control relay, then go to
step 9.
NO—Replace the engine mount control unit
(see page 11-323), then go to step 9.
9. Reconnect all connectors.
11-317