Honda ACCORD HYBRID 2005 Service Manual page 667

12. Disconnect the v a c u u m hose f r o m the PCS line (at
the EVAP canister side), and connect a T-fitting (A)
f r o m the v a c u u m gauge and the v a c u u m p u m p /
gauge, 0—30 in.Hg, to the hose as s h o w n .
13. Do the EVAP PCS ON in the INSPECTION MENU
w i t h the HDS.
14. S l o w l y apply about 2 kPa (0.6 in.Hg, 15 m m H g ) of
v a c u u m to the hose.
Does it hold vacuum?
YES—Check for a restricted PCS line between the
EVAP canister purge valve and the EVAP canister,
then go to step 24.
N O — G o t o step 15.
15. Remove the FTP sensor w i t h its connector
connected (see page 11-436).
16. Connect a T-fitting (A) f r o m the v a c u u m gauge and
a v a c u u m p u m p / g a u g e , 0—30 in.Hg, to the FTP
sensor (B) as s h o w n .
B
A
17. Check and record the FTP SENSOR reading in the
DATA LIST w i t h the HDS.
18. S l o w l y apply about 1.3 kPa (0.4 in.Hg, 10 m m H g ) of
v a c u u m to the hose.
19. Check the FTP SENSOR in the DATA LIST w i t h the
HDS.
Is there a difference of more than 1.1 kPa
(0.31 in.Hg, 8 mmHg) before and after applying
vacuum?
Y E S — G o t o step 20.
NO—Replace the FTP sensor (see page 11-436),
then go to step 25.
20. Reconnect the v a c u u m hoses to the PCS line (EVAP
canister side), and reinstall the FTP sensor.
(cont'd)
11-427