T r a n s m i s s i o n I n s t a l l a t i o n
1. Clean the ATF cooler (see page 14-254).
2. Install the torque converter (A) on the mainshaft (B)
w i t h the new O-ring (C).
3. Install the transmission lower m o u n t (A) w i t h the
10 x 1.25 m m bolts; 40 m m - l e n g t h (B) (one bolts)
and 35 m m - l e n g t h (C) (two bolts).
C
4. Install the rubber plates (D) on both side of the
mount.
5. Place the transmission on the jack, and raise it to
engine level.
6. Attach the transmission to the engine, and install
the transmission housing m o u n t i n g bolts.
(6.5 k g f m , 47 Ibf-ft)
7. Install the transmission housing m o u n t i n g bolts.
(cont'd)
14-243