Honda ACCORD HYBRID 2005 Service Manual page 527

8. Disconnect the engine mount control unit 20P
connector.
9. Check for continuity between engine mount control
unit 20P connector terminals No. 2 and No. 11 and
body ground.
ENGINE MOUNT CONTROL UNIT 20P CONNECTOR
PG1 (BLK)
1 2 3 4
i — i
5 6
/
8 9
10 11 12 / 1415 16 17 / / 20
PG2 (BLK)
Wire side of female terminals
Is there continuity?
Y E S — G o t o step 10.
NO—Repair open in the wire between the engine
mount control unit (No. 2, No. 11) and the G302,
then go to step 13.
10. Check for continuity between body ground and the
appropriate engine mount control unit (see table).
ENGINE MOUNT CONTROL UNIT 20P CONNECTOR
S O L R M
(GRN)
S O L F M
(YEL/GRN)
1 2 3 4
i — i
5 6
/
8 9
10 11 12
/
14 15 16 17
/ /
20
S O L R P
(LT BLU)
SOLFP
(BLU)
Wire side of female terminals
DTC ACTIVE CONTROL ENGINE WIRE
ENGINE MOUNT MOUNT
COLOR
(ACM) ACTUATOR CONTROL UNIT
TERMINAL TERMINAL
P0AB7 Rear side No. 1 No. 1 GRN
P0AB7 Rear side No. 2 No. 10 LT BLU
P0A15
Front side No. 1 No. 9 YEL/GRN
P0A15 Front side No. 2 No. 20 BLU
Is there continuity?
YES—Repair short in the wire between the engine
m o u n t control unit and the active control engine
mount (ACM) actuator, then go to step 13.
NO—Go to step 11.
(cont'd)
11-287