Honda ACCORD HYBRID 2005 Service Manual page 1438

Doors
Front Door Outer Handle Replacement (cont'd)
7. Driver's: Disconnect the lock cylinder switch
connector (A), and detach the harness clips (B),
t h e n remove the lock cylinder switch (C).
8. Remove the screws, then separate the lock cylinder
(A), lock cylinder switch (B), and lock cylinder
protector (C).
Fastener Locations
•
: S c r e w , 2
9. Remove the bolt, then r e m o v e the spacer (A).
Fastener Location
• : Bolt, 1
10.
11,
6 x 1 . 0 m m
9.8 N m (1.0
kgf
m, 7.2
Ibf ft)
W h i l e pulling the outer handle (A), remove the
handle f r o m the holes in the door panel. Take care
not to scratch the door.
Install the handle in the reverse order of removal,
and note these items:
• Make sure the lock cylinder switch harness is
routed properly.
• Make sure the lock cylinder switch connector is
plugged in properly, and each rod is connected
securely.
• Be sure that the end of the lock cylinder is
engaged w i t h the lock cylinder switch correctly.
• Make sure the door lock cylinder/door locks
operate properly.
• Make sure the door handle w o r k s properly.
• W h e n reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its outside perimeter to seal out water.
• Driver's: Perform the power w i n d o w control unit
reset procedure (see page 22-200).
20-10