Honda ACCORD HYBRID 2005 Service Manual page 1039

9. Turn the engine off, then disconnect the oil
pressure gauge f r o m the line pressure inspection
hole.
10. Install the sealing bolt to the line pressure
inspection hole w i t h the new sealing washer, and
tighten the bolt to 18 N-m (1.8 kgf-m, 13 Ibf-ft). Do
not reuse the old sealing washer.
11. Connect the oil pressure gauge to the 1 st clutch
pressure inspection hole (B).
12. Remove the intake air duct and air cleaner housing,
and connect the oil pressure gauge to the I s t - h o l d
clutch pressure inspection hole (C).
13. Connect the oil pressure gauge to the 2nd clutch
pressure inspection hole (D). Then t e m p o r a r i l y
install the air cleaner housing and intake air duct.
14. Start the engine, and shift to the 1 position.
Measure the 1st clutch pressure at the 1st clutch
pressure inspection hole (B) and the 1st-hold clutch
pressure at the 1st-hold clutch pressure inspection
hole (C) w h i l e holding the engine speed at
2,000 r p m .
15. Shift to the 2 position, and measure the 2nd clutch
pressure at the 2nd clutch pressure inspection hole
(D) w h i l e holding the engine speed at 2,000 r p m .
Pressure Fluid Pressure
Standard Service Limit
1st clutch 8 9 0 - 9 7 0 kPa 840 kPa
(B) ( 9 . 1 - (8.6 kgf/cm 2 ,
2nd clutch 9.9 kgf/cm 2 , 120 psi)
(D)
1 3 0 - 1 4 0 psi)
1st-hold 7 8 9 - 8 6 8 kPa 740 kPa
clutch (C) ( 8 . 0 5 - (7.55 kgf/cm 2 ,
8.85 kgf/cm 2 , 107 psi)
1 1 4 - 1 2 6 psi)
16. Turn the engine off, then disconnect the oil
pressure gauges f r o m the 1st clutch pressure, Ist-
hold clutch pressure, and 2nd clutch pressure
inspection holes.
17. Install the sealing bolts in the 1st clutch pressure,
1st-hold clutch pressure, and 2nd clutch pressure
inspection holes w i t h new sealing washers, and
tighten the bolts to 18 N-m (1.8 kgf-m, 13 Ibf-ft). Do
not reuse old sealing washers.
(cont'd)
14-203