Honda ACCORD HYBRID 2005 Service Manual page 764

IMA System
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
20. Check for continuity between the motor power
cable terminals (A) and (B), (B) and (C), (C) and (A)
individually.
Is there continuity?
YES—Replace the motor power cable (see page
12-148), then go to step 35.
NO—Replace the motor stator (see page 12-153),
then go to step 35.
2 1 . Reconnect the motor power cable.
22. Connect (clamp) your voltmeter lead (AC range) to
these terminals. Start the engine, and measure
voltage between these terminals at idle.
• The U phase terminal (A) and V phase terminal
(B).
• The W phase terminal (C) and V phase terminal
(B) .
• The U phase terminal (A) and W phase terminal
(C) .
NOTE:
• W h e n using clamp-type voltmeter leads, be
careful not to touch any other terminals.
• Battery module switch OFF.
A B C
Is each measurement about 30—43 V?
Y E S - G o t o step 27.
NO — G o to step 23.
23. Turn the ignition switch OFF.
24. Remove the motor power cable f r o m the MPI
module.
25. Turn the ignition switch ON (II).
12-86