Honda ACCORD HYBRID 2005 Service Manual page 1228

Driveline/Axle
I n t e r m e d i a t e S h a f t R e a s s e m b l y ( c o n t ' d )
Special Tools Required
• Driver 07749-0010000
• Attachment, 52 x 55 m m 07746-0010400
• Attachment, 35 m m I.D. 07746-0030400
• Oil seal driver 07GAD-PH70201
NOTE: Refer to the Exploded View as needed during
this procedure.
1. Clean the disassembled parts w i t h solvent, and dry
t h e m w i t h compressed air. Do not w a s h the rubber
parts w i t h solvent.
2. Press the intermediate shaft bearing (A) into the
bearing support (B) using the special tools and a
press.
07749-0010000
07746-0010400
3. Install, then seat the internal snap ring in the
groove of the bearing support.
16-24