Honda ACCORD HYBRID 2005 Service Manual page 1068

Automatic Transmission
T r a n s m i s s i o n R e m o v a l
Special Tools Required
• Engine support hanger, A and Reds AAR-T-12566
• Engine hanger balance bar VSB02C000019
• Front subframe adapter VSB02C000016
These special tools are available t h r o u g h the Honda
Tool and Equipment Program 1-888-424-6857.
NOTE: Use fender covers to avoid d a m a g i n g painted
surfaces.
1. Make sure you have the customer's radio anti-theft
code (navigation code), and write d o w n the
customer's audio presets.
2. Remove the bolts securing the support strut
bracket on the right side h o o d . Raise and secure the
hood (A) in a vertical position, then install the strut
bracket (B) by t u r n i n g it over w i t h its bolt in lower
position.
NOTE: Do not attempt t o close the hood w i t h the
support strut in the vertical position; it w i l l damage
the support strut and the h o o d .
3. Make sure the ignition switch is OFF. Disconnect
the negative terminal f r o m the battery, then
disconnect the positive t e r m i n a l .
4. Remove the battery h o l d - d o w n bracket, and
remove the battery and battery tray.
5. Remove the intake air duct and air cleaner housing.
6. Remove the battery base.
7. Disconnect the steering joint (see page 17-9).
8. Remove the splash shield.
9. Remove the drain plug (A), and drain the automatic
transmission fluid (ATF).
10. Reinstall the drain plug w i t h a new sealing washer
(B).
14-232