Honda ACCORD HYBRID 2005 Service Manual page 1106

A / T Gear Position Indicator
T r a n s m i s s i o n R a n g e S w i t c h T e s t
1. Get the customer's radio anti-theft code (navigation
code), and write d o w n the customer's audio
presets.
2. Disconnect the negative terminal f r o m the battery,
then disconnect the positive t e r m i n a l .
3. Remove the battery h o l d - d o w n bracket, and
remove the battery and battery tray.
4. Remove the intake air duct and air cleaner housing.
5. Remove the battery base.
6. Disconnect the transmission range switch
connector.
7. Check for continuity between the terminals at the
switch connector. There should be continuity
between the terminals in the f o l l o w i n g table for
each switch position.
Transmission Range Switch Connector
Connector Terminal/Signal
1 2 3 4 5 6 7
8 9 10
2-1 D R P
GND ATP
FWD
D3
N ATP
R V S
ATP
NP
P
O -o
P
O
\ J
w
-o
R
r\ r\ r\
R
\ J KJ
N
r v
o o
N
KJ
o o
D
r\
r y
o
D
w
o
D3
o-
o
o
2
o
2
KJ
o
1
r~\
1
8. The transmission range switch test is finished if the
test results are OK.
If there is no continuity between any terminals,
check that transmission range switch installation. If
the switch installation is OK, replace the switch
(see page 14-271).
9. Check the connectors for rust, dirt, or oil, clean or
repair if necessary, then connect the connector
securely.
10. I n s t a l l t h e b a t t e r y b a s e .
11. Install the intake air duct and air cleaner housing.
12. Install the battery tray, battery, and battery hold-
d o w n bracket, then connect the battery terminals.
13. Enter the radio code (navigation code), then enter
the customer's audio presets, and set the clock.
14. Do the power w i n d o w control unit reset procedure
(see page 22-200).
15. If the IMA battery level gauge (BAT) displays no
segments, start the engine in the P or N position,
and hold it between 3,500 and 4,000 r p m w i t h no
load until the BAT displays at least three segments.
14-270