Honda ACCORD HYBRID 2005 Service Manual page 1042

Automatic Transmission
S h i f t S o l e n o i d V a l v e T e s t a n d R e p l a c e m e n t
1. Connect the HDS to the DLC (A).
2. Choose Shift Solenoid A, B, C, and D in
Miscellaneous Test M e n u on the HDS.
3. Check that the shift solenoid valve A, B, C, and D
operate w i t h the HDS. A clicking sound should be
heard.
• If a clicking sound is heard, the valves are OK.
• If no clicking sound is heard, go to step 4.
4. Shift solenoid test has finished if the tests are OK. If
no sound is heard, r e m o v e the shift solenoid valve,
and test the solenoid valve.
5. Get the customer's radio anti-theft code (navigation
code), and write d o w n the customer's audio
presets.
6. Disconnect the negative t e r m i n a l f r o m the battery,
then disconnect the positive t e r m i n a l .
7. Remove the battery h o l d - d o w n bracket, and
remove the battery and battery tray.
8. Remove the intake air duct and air cleaner housing.
10. Remove the nuts securing the shift cable bracket
(A).
6 x 1 . 0 m m
9.3 N m
(1.0 kgf-m, 7.2 Ibf-ft)
11 Remove the spring clip/washer (B) and the control
pin (C), then separate the shift cable end (D) f r o m
the control lever (E).
12. Disconnect the connectors f r o m the A/T clutch
pressure control solenoid valve A, B, solenoid
harness, transmission range switch, ATF
temperature sensor, output shaft (countershaft)
speed sensor, input shaft (mainshaft) speed sensor,
3rd clutch transmission fluid pressure switch, and
4th clutch transmission fluid pressure switch.
9. Remove the battery base.
14-206