Honda ACCORD HYBRID 2005 Service Manual page 1453

7. Check for water leaks. Run water over the roof and
on the sealing area as s h o w n , and note these items:
• Use a 12 m m (0.5 in.) diameter hose (A).
• Adjust the rate of water f l o w as s h o w n (B).
• Do not use a nozzle.
• Hold the hose about 300 m m (12 in.) away f r o m
the door (C).
8. Attach the plastic cover, and install the door panel,
front door (see page 20-7), rear door (see page
20-15).
9. Driver's: Perform the power w i n d o w control unit
reset procedure (see page 22-200).
10. Test-drive and check for w i n d noise.
Front and Rear Door Position
Adjustment
SRS c o m p o n e n t s are located in this area. Review the
SRS c o m p o n e n t locations (see page 24-11) and the
precautions and procedures (see page 24-13) before
p e r f o r m i n g repairs or servise.
NOTE: Check for a flush fit w i t h the body, then check for
equal gaps between the front, rear, and b o t t o m door
edges and the body. Check that the door and body
edges are parallel.
1. Place the vehicle on a f i r m , level surface when
adjusting the doors.
2. Adjust at the hinges (A):
• On the front door: Remove the front inner fender
(see page 20-121) and f r o n t fender fairing
(see page 20-123). Loosen the hinge mounting
bolts (B) slightly, and m o v e the door backward or
f o r w a r d , up or d o w n as necessary to equalize the
gaps. Place a shop t o w e l (C) on the jack (D) to
prevent damage w h e n adjusting the door.
• On the rear door: Remove the B-pillar lower t r i m
(see page 20-48) and remove the front seat belt
and retractor (see page 24-4), and the plug seal
f r o m the body. Loosen the hinge m o u n t i n g nuts
(E) slightly, and m o v e the door backward or
f o r w a r d , up or d o w n as necessary to equalize the
gaps. Place a shop t o w e l on the jack to prevent
damage w h e n adjusting the door.
Front door
(cont'd)
20-25