Honda ACCORD HYBRID 2005 Service Manual page 1484

Interior Trim
Trim Removal/Installation - Trunk
Lid (cont'd)
2. Remove the trunk lid protector (A).
- 1 Pull back the outside of the protector to release
the outside hook (B).
- 2 Slide the protector outside, then release the
hooks (C) to remove it.
C
3. Install the t r i m in the reverse order of removal, and
note these items:
• Replace any damaged clips.
• Push the clips into place securely.
Headliner Removal/Installation
Special Tools Required
KTC t r i m tool set SOJATP2014 *
• Available through the A m e r i c a n Honda Tool and
Equipment Program; call 888-424-6857
SRS components are located in this area. Review the
SRS c o m p o n e n t locations (see page 24-11) and the
precautions and procedures (see page 24-13) before
p e r f o r m i n g repairs or service.
NOTE:
• Use the appropriate tool f r o m the KTC t r i m tool set to
avoid damage w h e n prying componets.
• W h e n prying w i t h a flat-tip screwdriver, w r a p it w i t h
protective tape to prevent damage.
• Take care not to bend or scratch the headliner.
• Be careful not to damage the dashboard and other
interior t r i m .
1. Remove these items:
• A-pillar t r i m , both sides (see page 20-47)
• Ceiling light (see page 22-189)
• Front seat belt upper anchor, both sides (see step
6 on page 24-4)
• B-pillar lower t r i m (see page 20-48)
• B-pillar upper t r i m , both sides (see page 20-48)
• C-pillar t r i m , both sides (see page 20-50)
2. From both sides, using a t r i m t o o l , release the tabs
(A), then turn the sunvisor cap (B), and remove it
f r o m the bracket (C).
20-56