Honda ACCORD HYBRID 2005 Service Manual page 824

IMA System
P D U / D C - D C C o n v e r t e r H e a t s i n k A i r
D u c t R e m o v a l / I n s t a l l a t i o n
NOTE: Put on gloves to protect y o u r hands f r o m
electrical shock.
I M A components are located in this area. The IMA is a
high-voltage system. You must be familiar w i t h the IMA
system before w o r k i n g on or a r o u n d it. Make sure y o u
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Remove the MPI m o d u l e (see page 12-144).
2. Remove the DC-DC converter (see page 12-143).
3. Remove the A/C compressor driver (see page
21-99).
4. Remove the bolts (A) and PDU/DC-DC converter
heatsink air duct (B).
A
9.8 N-m (1.0 k g f m , 7.2 Ibf-ft)
B
5. Install the parts in the reverse order of removal.
B a t t e r y M o d u l e R e m o v a l /
I n s t a l l a t i o n
NOTE: Put on gloves to protect your hands f r o m
electrical shock.
IMA components are located in this area. The IMA is a
high-voltage system. You must be familiar w i t h the IMA
system before w o r k i n g on or around it. Make sure y o u
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Disconnect the negative cable to the 12 V battery.
2. Remove the IPU lid (see page 12-140).
3. Remove the high voltage cables (A), then w r a p
t h e m w i t h insulating tape (B).
4. Disconnect the M C M connector (C), and battery
module connector (D).
5. Remove the spare tire lid and the trunk front t r i m
panel (see page 20-53).
12-146