Honda ACCORD HYBRID 2005 Service Manual page 1475

3. Pull out the rear door opening t r i m (A) f r o m the
t r i m hooks (B) and around the rear door opening
flange, then remove the t r i m .
4. Install the t r i m in the reverse order of removal, and
note these items:
• Replace any damaged clips.
• Push the clips and hooks into place securely.
Trim Removal/Installation
Areas
Pillar
Special Tools Required
KTC t r i m tool set SOJATP2014 *
• Available t h r o u g h the A m e r i c a n Honda Tool and
Equipment Program; call 888-424-6857
A-pillar
SRS c o m p o n e n t s are located in this area. Review the
SRS c o m p o n e n t locations (see page 24-11) and the
precautions and procedures (see page 24-13) before
p e r f o r m i n g repairs or service.
NOTE:
• Put on gloves to protect your hands.
• Take care not to bend or scratch the t r i m and panels.
• Use the appropriate tool f r o m the KTC t r i m tool set to
avoid damage w h e n prying c o m p o n e n t s .
1. Remove the A-pillar t r i m (A).
- 1 Pull out the door opening t r i m (B) as needed.
- 2 Pry the A-pillar cap (C) out until it is stopped by
the hooks (D) in the g r o m m e t (E).
- 3 Pull the t r i m back by hand to detach the clip,
then pull the t r i m up.
- 4 Release the hooks on the g r o m m e t and pull the
cap out. Discard the cap.
Fastener Location
>
Clip, 1
(White)
(cont'd)
20-47