Honda ACCORD HYBRID 2005 Service Manual page 1094

Automatic Transmission
S h i f t L e v e r I n s t a l l a t i o n
1. Install the shift lever assembly.
B
2. Connect the shift lock solenoid connector (A) and
park pin switch/A/T gear position indicator panel
light connector (B), and install the harness clamps
(C) on the shift lever bracket base.
3. Turn the ignition switch ON (II), and verify that the
R position indicator comes o n .
z;^,.^,,, /J$o ^ ^ w . i 2 a \ ^ \
o p
o
R
o
N
o
D
o
D3
o 2
o
1
4. If necessary, push the shift cable until it stops, t h e n
release it. Pull the shift cable back one step so that
the shift position is in R. Do not hold the shift cable
guide (A) and d a m p e r (B) to adjust the shift cable
(C).
5. Turn the ignition switch OFF.
6. Place the shift lever in the R position, then insert a
6.0 m m (0.24 in.) pin (A) t h r o u g h the positioning
hole (B) on the shift lever bracket base, t h r o u g h the
positioning hole on the shift lever, and into the
positioning hole on the shift lever bracket base. The
shift lever is secured in the R position.
B A
14-258