Honda ACCORD HYBRID 2005 Service Manual page 1098

Automatic Transmission
S h i f t C a b l e R e p l a c e m e n t ( c o n t ' d )
13. Remove the harness c l a m p (A) f r o m the shift cable
bracket (B), then remove the bolt securing the
bracket.
14. Remove the heat shield under the shift cable
g r o m m e t .
15. Remove the shift cable g r o m m e t , and pull out the
shift cable.
16. Insert the new shift cable t h r o u g h the g r o m m e t
hole, and install the g r o m m e t in its hole. Do not
bend the shift cable excessively.
17. Install the heat shield.
18. Secure the shift cable bracket on the f r o n t
subframe w i t h the bolt, then install the harness
clamp on the bracket.
19. Attach the shift cable end to the control lever, then
insert the control pin into the control lever hole
t h r o u g h the shift cable end, and secure the control
pin w i t h the spring clip/washer.
20. Secure the shift cable bracket.
21. Turn the ignition switch ON (II), and verify that the
R position indicator comes on.
22. If necessary, push the shift cable until it stops, then
release it. Pull the shift cable back one step so that
the shift position is in R. Do not hold the shift cable
guide (A) and damper (B) to adjust the shift cable
(C).
23. Turn the ignition switch OFF.
14-262