Honda ACCORD HYBRID 2005 Service Manual page 1273

DTC 30, 31, 32, 33, 34, 35, 38: EPS Control
Unit Internal Circuit
1. Turn the ignition switch ON (II).
2. Clear the DTC w i t h the HDS.
3. Start the engine.
4. Wait at least 10 seconds.
Does the EPS indicator come on?
Y E S — G o t o step 5.
NO—The system is OK at this t i m e . •
5. Stop the engine, and verify the DTC.
Is DTC 30, 31, 32, 33, 34, 35 or 38 indicated?
YES—Check for loose terminals and poor
connections at EPS control unit. If necessary,
substitute a known-good EPS control unit and
recheck. •
NO—Perform the appropriate troubleshooting for
the DTC i n d i c a t e d . •
DTC 36: Change of the Motor Voltage
1. Turn the ignition switch ON (II).
2. Clear the DTC w i t h the HDS.
3. Start the engine.
4. Turn the steering wheel to right or left, and wait
10 seconds or more.
Does the EPS indicator come on?
Y E S — G o t o step 5.
NO—The system is OK at this t i m e . •
5. Stop the engine, and verify the DTC.
Is DTC 36 indicated?
Y E S — G o t o step 6.
NO—Perform the appropriate troubleshooting for
the DTC i n d i c a t e d . •
6. Turn the ignition switch OFF.
7. Check the No. 22 (EPS) (70 A) fuse in the under-
hood fuse/relay box.
Is the fuse OK?
Y E S — G o t o step 8.
NO—Replace the fuse and r e c h e c k . •
8. Disconnect EPS control unit connector B (2P).
(cont'd)
17-41