Honda ACCORD HYBRID 2005 Service Manual page 1515

F r o n t S e a t L u m b a r S u p p o r t R e p l a c e m e n t
Special Tools Required
KTC t r i m tool set SOJATP2014 *
• Available t h r o u g h the A m e r i c a n Honda Tool and
Equipment Program; call 888-424-6857
Driver's Seat
SRS c o m p o n e n t s are located in this area. Review the
SRS c o m p o n e n t locations (see page 24-11) and the
precautions and procedures (see page 24-13) before
p e r f o r m i n g repairs or service.
NOTE:
• Use the appropriate tool f r o m the KTC t r i m tool set to
avoid damage w h e n prying c o m p o n e n t s .
• Take care not to bend the cable.
• Take care not to tear the seams or damage the seat
covers.
• Put on gloves to protect your hands.
1. Remove these items:
• Lumbar support knob (see step 5 on page 20-89)
• Back panel (see step 6 on page 20-90)
2. Release the hook strips on the inside of the seat-
back (see step 7 on page 20-90).
3. Remove the screws securing the lumbar support
actuator (A).
Fastener Locations
• : S c r e w , 2
4. Release the hook of the yoke w i r e (A) f r o m t o p of
the basket (B) to loosen the l u m b a r support cable
(C), then disconnect it.
5. Release the w i r e tie (A), then remove the l u m b a r
support cable (B) and actuator (C) as an assembly.
(cont'd)
20-87