Honda ACCORD HYBRID 2005 Service Manual page 1216

Driveline/Axle
D r i v e s h a f t R e a s s e m b l y (cont'd)
6. Pack the inboard joint w i t h the joint grease
included in the new driveshaft set.
Grease quantity
Inboard joint: 150—160 g (5.3—5.6 oz)
7. Fit the inboard joint onto the driveshaft, and note
these items:
• Reinstall the inboard joint onto the driveshaft by
aligning the marks (A) on the inboard joint and
the rollers.
• Hold the driveshaft so the inboard joint is
pointing up to prevent it f r o m falling off.
A
8. Install the boot bands.
• For the double loop t y p e , go to step 13.
(Boot band replacement only)
• For the low profile type, go to step 9.
9. Install the new low profile band (A) onto the boot
(B), then hook the tab (C) of the band.
B
10. Close the hook portion of the band w i t h
commercially available boot band pincers (A), then
hook the tabs (B) of the band.
11. Install the boot band on the other end of the boot,
and repeat steps 9 t h r o u g h 10.
16-12