Honda ACCORD HYBRID 2005 Service Manual page 1127

M a i n s h a f t B e a r i n g R e m o v a l
Special Tools Required
• Driver 07749-0010000
• Attachment, 78 x 80 m m 07NAD-PX40100
1. To remove the mainshaft bearing, expand the snap
ring w i t h the snap ring pliers, then push the bearing
out. Do not remove the snap ring unless it's
necessary to clean the groove in the housing.
M a i n s h a f t B e a r i n g I n s t a l l a t i o n
Special Tools Required
• Driver 07749-0010000
• Attachment, 78 x 80 m m 07NAD-PX40100
1. Install the bearing in the direction s h o w n .
07NAD-PX40100
2. Expand the snap ring w i t h the snap ring pliers, and
insert the bearing part-way into the housing.
3. Release the pliers, then push the bearing d o w n into
housing until the snap ring snaps in place around it.
4. After installing the bearing, verify that the snap ring
(A) is seated in the bearing and housing groove,
and that the ring end gap (B) is 0—7 m m (0—0.28 in.).
B
14-291