Honda ACCORD HYBRID 2005 Service Manual page 1298

EPS Components
E P S C o n t r o l U n i t R e m o v a l / I n s t a l l a t i o n
1. Make sure you have the anti-theft codes for the
radio and the navigation system (if equipped), then
w r i t e d o w n the X M radio channel presets.
2. Make sure the ignition switch is OFF, then
disconnect the negative cable f r o m the battery.
3. Remove the passenger's dashboard lower cover
(see page 20-72).
4. Remove the passenger's side kick panel (see page
20-45).
5. Disconnect the EPS control unit connectors (A).
B
6. Loosen the flange bolt (B), and remove the flange
bolts (C).
7. Remove the EPS control unit (D).
8. Install the EPS control unit in the reverse order of
removal.
9. Reconnect the negative cable to the battery and do
the f o l l o w i n g items:
NOTE: If the IMA battery level gauge (BAT) displays
no segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
• Power w i n d o w control unit reset procedure
(see page 22-200).
• Enter the anti-theft codes for the radio and the
navigation system, then enter the X M radio
channel presets.
• Set the clock.
• If the EPS control unit is replaced, the EPS control
unit must memorize the torque sensor neutral
position (see page 17-21).
10. After installation, start the engine, and let it idle.
Turn the steering wheel f r o m lock-to-lock several
times. Check that the EPS indicator does not come
on.
17-66