Honda ACCORD HYBRID 2005 Service Manual page 1041

27. Bring the engine back to an idle, then apply the
brake pedal to stop the wheels f r o m rotating.
28. Shift to the R position, then release the brake pedal.
Raise the engine speed to 2,000 r p m , and measure
the 5th clutch pressure at the 5th clutch pressure
inspection hole (G).
Pressure Fluid Pressure Pressure
Standard Service Limit
5th clutch
(G) in R
8 9 0 - 9 7 0 kPa
( 9 . 1 -
9.9 kgf/cm 2 ,
1 3 0 - 1 4 0 psi)
840 kPa
(8.6 kgf/cm 2 ,
120 psi)
29. Turn the engine off, then disconnect the oil
pressure gauges f r o m the 3rd, 4th, and 5th clutch
pressure inspection holes.
30. Install the sealing bolts in the 3rd, 4th, and 5th
clutch pressure inspection holes w i t h new sealing
washers, and tighten the bolts to 18 N-m (1.8 kgf-m,
13 I b f f t ) . Do not reuse old sealing washers.
3 1 . If the measurements are out of the service limit,
problems and probable causes are listed in the
table.
Problem Probable causes
No or l o w line
pressure
• Torque converter
• ATF p u m p
• Regulator valve
• Torque converter
check valve
• Low fluid level
• Clogged ATF strainer
No or l o w 1st clutch
pressure
• 1st clutch
• O-rings
No or l o w 2nd clutch
pressure
• 2nd clutch, or 1st
clutch
• O-rings
No or low 3rd clutch
pressure
• 3rd clutch, or 1st
clucth
• O-rings
No or l o w 4th clutch
pressure
• 4th clutch, or 1st
clutch
• O-rings
No or low 5th clutch
pressure
• 5th clutch, or 1st
clutch
• O-rings
No or l o w 5th clutch
pressure in the R
position
• Servo valve
• 5th clutch
• O-rings
No or l o w 1st-hold
clutch pressure
• 1st-hold clutch, or 1st
clutch
• O-rings
32. Install the air cleaner housing and intake air duct.
33. Install the splash shield.
14-205