Honda ACCORD HYBRID 2005 Service Manual page 1095

7. Align the socket holder (A) on the shift cable (B)
w i t h the slot in the bracket base (C), then slide the
holder into the base. Install the shift cable end (D)
over the m o u n t i n g stud (E) by aligning its square
hole (F) w i t h the square fitting (G) at the b o t t o m of
the stud. Push the holder until it snaps securely in
place. Do not install the shift cable by holding the
shift cable guide (H) and damper (I).
8. Verify that the shift cable end (A) is properly
installed on the m o u n t i n g stud (B).
Properly Installed:
A B
Improperly Installed:
Cable end rides on the b o t t o m of the m o u n t i n g s t u d .
9. If i m p r o p e r l y installed, remove the shift cable f r o m
the bracket base, and reinstall the shift cable. Do
not install the shift cable end on the m o u n t i n g stud
w h i l e the shift cable is on the bracket base.
10. Install and tighten the nut.
11. Remove the 6.0 m m (0.24 in.) pin that was installed
to hold the shift lever.
12. Move the shift lever to each position, and verify
that the A/T gear position indicator f o l l o w s the
transmission range switch.
13. Push the shift lock release, and verify that the shift
lever releases.
14. Reinstall the center console (see page 20-62).
14-259