Honda ACCORD HYBRID 2005 Service Manual page 1290

EPS Components
S t e e r i n g G e a r b o x R e m o v a l a n d I n s t a l l a t i o n (cont'd)
24. Install the connector stay (A) and the g r o u n d male
t e r m i n a l (B) to the steering gearbox, and install the
connector (C) to the connector stay.
6 x 1.0 mm
9.8 N m (1.0 k g f m ,
7.2 Ibf ft)
25. Remove the vinyl tape, then connect the motor 2P
connector (D) and g r o u n d t e r m i n a l (E) to the
steering gearbox. Make sure t o push the motor 2P
connector until y o u hear a click so that the
connector is secured.
26. Connect the torque sensor 3P connector (A) to the
steering gearbox. Make sure to push the connector
until you hear a click so that the connector is
secured.
27. Install the splash shield (A).
28. Wipe off any grease f r o m the ball joint tapered
section and threads. Then reconnect the tie-rod end
(A) to the knuckle arms.
10 x 1.25 m m
43 N m
(4.4 kgf m, 32 Ibf-ft)
29. Install the tie-rod end ball joint nut, and tighten it to
the specified torque. Then install the new cotter pin
(B), and bend it as s h o w n (C) or (D).
17-58