Honda ACCORD HYBRID 2005 Service Manual page 1210

Driveline/Axle
D r i v e s h a f t D i s a s s e m b l y ( c o n t ' d )
3. Make a mark (A) on each roller (B) and inboard joint
(C) to identify the locations of rollers and grooves
in the inboard joint. Then r e m o v e the inboard joint
on the shop towel (D). Be careful not to drop the
rollers w h e n separating t h e m f r o m the inboard
joint.
C
D
A
4. Make a mark (A) on the rollers (B) and spider (C) to
identify the locations of the rollers on the spider,
then remove the rollers.
D A
5. Remove the circlip (D).
6. Mark the spider and driveshaft (E) to identify the
position of the spider on the shaft.
7. Remove the spider.
8. W r a p the splines on the driveshaft w i t h vinyl tape
(A) to prevent damage to the boot.
9. Remove the inboard boot. Be careful not to damage
the boot.
10. Remove the vinyl tape.
16-6