Honda ACCORD HYBRID 2005 Service Manual page 1189

43. Install the new locknut and tighten it to 176 N-m
(18.2 kgf-m, 132 I b f f t ) , then stake the locknut into
its shaft in depth (A) of 0.7—1.3 m m (0.03—0.05 in.)
using a 3.5 m m punch (B).
44. Install the end cover (A), d o w e l pin (B), and n e w CD-
ring (C).
47. Install the new O-ring (E) on the solenoid harness
connector (F).
48. Route the solenoid harness t h r o u g h the
transmission housing, and install the solenoid
harness connector.
49. Connect the GRN harness connector to the shift
solenoid valve C.
50. Connect the YEL harness connector to the shift
solenoid valve A.
5 1 . Connect the RED harness connector to the shift
solenoid valve B.
52. Connect the ORN harness connector to the shift
solenoid valve D.
53. Secure the solenoid harness connector w i t h the
bolt on the transmission housing.
45. Install the snap ring cap (D) w i t h the new O-ring (E).
46. A p p l y thread lock sealant to the threads of the
sealing plug (F), and install the sealing plug and the
new sealing washer (G).
(cont'd)
14-353