Honda ACCORD HYBRID 2005 Service Manual page 1100

Automatic Transmission
S h i f t C a b l e R e p l a c e m e n t ( c o n t ' d )
27. If i m p r o p e r l y installed, remove the shift cable f r o m
the bracket base, and reinstall the shift cable. Do
not install the shift cable end on the m o u n t i n g stud
w h i l e the shift cable is on the bracket base.
28. Install and tighten the nut.
29. Remove the 6.0 m m (0.24 in.) pin that w a s installed
to hold the shift lever.
30. Install the battery base.
3 1 . Install the intake air duct and air cleaner housing.
32. Install the battery tray, battery, and battery hold-
d o w n bracket, then connect the battery terminals.
33. M o v e the shift lever to each position, and verify
that the A/T gear position indicator f o l l o w s the
t r a n s m i s s i o n range switch.
34. A l l o w the f r o n t wheels to rotate freely.
35. Start the engine, and check the shift lever operation
in all gears.
36. Push the shift lock release, and verify that the shift
lever releases.
37. Reinstall the center console (see page 20-62).
39. Do the power w i n d o w control unit reset procedure
(see page 22-200).
40. If the IMA battery level gauge (BAT) displays no
segments, start the engine in the P or N position,
and hold it between 3,500 and 4,000 rpm w i t h no
load until the BAT displays at least three segments.
38. Enter the radio code (navigation code), then enter
the customer's audio presets, and set the clock.
14-264