Honda ACCORD HYBRID 2005 Service Manual page 661

6. Turn the ignition switch OFF.
7. Turn the ignition switch ON (II).
8. Check for a poor connection or damage at the fuel
tank vapor recirculation tube.
Is the tube OK?
YES—Go to step 9.
N O -
• Replace the fuel tank vapor recirculation tube,
then go to step 24.
• If necessary, replace the fuel tank (see page
11-367), then go to step 24.
9. Remove the EVAP system cover.
10. Remove the EVAP canister lower cover.
11. Disconnect the fuel tank vapor recirculation tube
(A) f r o m the EVAP canister (B), and plug the EVAP
canister port (C).
B C
12. Disconnect the v a c u u m hose (purge line) f r o m the
EVAP canister purge valve (A) in the engine
c o m p a r t m e n t , and connect a T-fitting (B) f r o m the
v a c u u m gauge and the v a c u u m p u m p / g a u g e ,
0—30 in.Hg, to the hose as s h o w n .
13. Do the EVAP CVS ON in the INSPECTION MENU
w i t h the HDS.
14. A p p l y v a c u u m to the hose until the FTP reads
1.90 V (0.59 in.Hg, - 1 5 . 1 m m H g ) .
15. M o n i t o r the FTP SENSOR in the DATA LIST for
1 minute w i t h the HDS.
Does the voltage rise less than 0.2 V (0.1 in.Hg,
0.5 mmHg)?
YES—Go to step 2 1 .
N O — G o t o step 16.
(cont'd)
11-421