Honda ACCORD HYBRID 2005 Service Manual page 1502

Dashboard
D a s h b o a r d / S t e e r i n g H a n g e r B e a m
4. Remove the screw (A) and release the clip (B), then
r e m o v e the driver's center lower cover (C) by
releasing the hooks (D).
Fastener Locations
A • : S c r e w , 1 B > : Clip, 1
5. Release the clip, then remove the passenger's
center lower cover (A) and the rear vent duct (B) by
releasing the hooks (D) and the hook (E).
Fastener Location
D > : Clip, 1
6. Remove the SRS control unit (see page 24-153).
o v a l / I n s t a l l a t i o n ( c o n t ' d )
Driver's side
7. From under the dash, disconnect the interior w i r e
harness connector (A), brake switch connector (B),
idle stop switch connector (C), floor w i r e harness
connectors (D), engine c o m p a r t m e n t w i r e harness
connectors (E), and disconnect the dashboard w i r e
harness connectors (F) f r o m the under-dash fuse/
relay box (G), then detach the connector clip (H).
Disconnect the air hose (I).
NOTE: Lift the white w i r e harness connector locks
(J) before trying to remove the connectors f r o m the
fuse box.
H
F A F
20-74