Honda ACCORD HYBRID 2005 Service Manual page 1202

A / T Differential
C a r r i e r B e a r i n g P r e l o a d I n s p e c t i o n ( c o n t ' d )
7. Install the differential assembly (A) in the torque
converter housing (B), and install the gasket (C) and
the t w o dowel pins (D) on the housing.
10 x 1.25 m m
44 N m
{4.5 k g f m , 33 Ibfft)
22 Bolts
G
12 x 1.25 mm
64 N m
(6.5 k g f m ,
47 Ibfft)
10 x 1.25 m m
39 N m
(4.0 kgf-m,
29 Ibfft)
2 Bolts
Install the transmission housing (E), and install the
m o u n t i n g bolts (23 bolts) w i t h the transmission
hangers (F) and the g r o u n d terminal bracket (G),
then tighten the bolts.
9. Rotate the differential assembly in both directions
to seat the bearings.
10. Measure the starting t o r q u e of the differential
assembly w i t h the special t o o l , a torque w r e n c h (A),
and a socket (B). Measure the starting torque at
normal r o o m temperature in both directions.
Standard
New bearings:
3 . 9 - 5 . 1 N-m ( 4 0 - 5 2 kgf-cm, 3 5 - 4 5 Ibf-in.)
Reused bearings:
3 . 6 - 4 . 8 N-m ( 3 7 - 4 9 kgf-cm, 3 2 - 4 3 Ibf-in.)
07YAJ-S3V0100
11. If the measurement is out of standard, remove the
thrust shim and measure its thickness.
14-366