Honda ACCORD HYBRID 2005 Service Manual page 1422

A B S / T C S Components
T C S P r e s s u r e S e n s o r N e u t r a l P o s i t i o n
1. W i t h the ignition switch OFF, connect the HDS to
the 16Pdate link connector (DLC) (A) under the
driver's side of the dashboard.
2. Short the SCS circuit to body g r o u n d using the HDS.
3. The system w i l l s h o w the message: The SCS line
has been shorted. Do y o u w a n t to leave the SCS
line shorted? Choose YES.
M e m o r i z a t i o n
4. Turn the ignition switch ON (II).
5. The ABS indicator comes on for 2 seconds.
6. Push the TCS OFF switch once w i t h i n 2 seconds
after the ABS indicator goes off.
7. Push the TCS OFF switch once w i t h i n 2 seconds
after the ABS indicator comes back on.
8. The TCS activation indicator blinks, and the system
starts TCS pressure sensor neutral position
memorization.
9. W h e n the ABS indicator, TCS indicator and TCS
activation indicator go off, the m e m o r i z i n g is done.
If the indicators do not go off, retry these steps.
NOTE: On the left bottom side of the HDS screen
y o u w i l l notice " S C S " blinking during steps 4 to 9.
10. Disconnect the HDS f r o m the DLC, or go back into
the SCS m e n u and remove the short f r o m there.
11. If the indicators do not go OFF, retry step 10.
19-78