Honda ACCORD HYBRID 2005 Service Manual page 1490

Consoles
C e n t e r C o n s o l e R e m o v a l / I n s t a l l a t i o n
Special Tools Required
KTC t r i m tool set SOJATP2014 *
• Available t h r o u g h the A m e r i c a n Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
• Take care not to scratch the front seat, dashboard,
and related parts.
• Use the appropriate tool f r o m the KTC t r i m tool set to
avoid damage w h e n prying c o m p o n e n t s .
1. Detach the clips (A, B) by pulling the center console
front panel (C) up. Disconnect the seat heater
switch connectors (D).
Fastener Locations
A D>: Clip, 2 B t > : C l i p , 4
A
D
2. Pry up on both rear corner gaps under the rubber
surface of the console pocket (A) w i t h a t r i m t o o l ,
and detach the clips, then remove the pocket.
Fastener Locations
D > : Clip, 2
3. Remove the screws (A), detach the hook (B) by
pulling the center holder (C) up, and disconnect the
front accessory power socket connector (D).
Fastener Locations
A • : S c r e w , 2 B > : Hook, 1
20-62