Honda ACCORD HYBRID 2005 Service Manual page 1297

7. Install the torque senser core/pinion shaft assmbly
on the gearbox housing by engaging the gear, then
install the snap ring.
8. Coat the new O-ring w i t h grease, and carefully fit it
on the gearbox houshing, then install the torque
sensor coil.
9. Install and tighten the 6 m m flange bolts to the
specified torque.
10. Install the rack guide.
11. Reinstall the steering gearbox (see page 17-54).
12. Adjust the rack guide screw (see page 17-14).
R a c k G u i d e R e m o v a l / I n s t a l l a t i o n
NOTE: During removal/installation, do not allow dust,
dirt, or other foreign materials to enter the gearbox.
1. Remove the steering gearbox (see page 17-47).
2. Loosen the locknut (A), then remove the rack guide
screw (B), spring (C), and rack guide (D).
3. A p p l y multipurpose grease to the sliding surface of
the rack guide, and install it onto the gearbox
housing. W i p e the grease off the threaded section
(E) of the housing.
4. Replace the O-ring (F), and carefully fit it on the
rack guide screw groove.
5. Position the spring, and loosely install the rack
guide screw and lockout.
6. Adjust the rack guide screw (see page 17-14).
After adjusting, check that the rack moves
s m o o t h l y by sliding the rack right and left.
17-65