Honda ACCORD HYBRID 2005 Service Manual page 595

11. After disconnecting the quick-connect fitting, check
it for dirt or damage (see step 4 on page 11-361).
12. Reconnect the negative cable to the battery, and do
these items:
• Power w i n d o w control unit reset procedure
(see page 22-200).
• Enter the anti-theft codes for the radio and the
navigation system, then enter the customer's
audio presets.
• Reset the clock.
• If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 rpm and 4,000 rpm w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
Without the HDS
1. Make sure you have the anti-theft code for the radio,
and the navigation system, then write d o w n the
customer's audio presets.
2. Remove the left kick panel (see page 20-45), then
remove PGM-FI main relay 2 (FUEL PUMP) (A) f r o m
the under-dash fuse/relay box.
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore
t h e m .
4. Turn the ignition switch OFF.
5. Remove the fuel fill cap.
6. Disconnect the negative cable f r o m the battery.
7. Remove the quick-connect fitting cover (A).
(cont'd)
11-355