Honda ACCORD HYBRID 2005 Service Manual page 1407

r
ABS
DTC 65: Brake Fluid Level
1. Check the brake fluid level.
Is the level correct?
Y E S — G o t o step 2.
NO—Inspect the brake system for fluid leaks, if no
leaks are f o u n d , replace all w o r n out brake p a d s . B
2. Check for short in the GRN/RED w i r e between the
gauge control m o d u l e and the brake fluid level
switch. If OK, check the brake fluid level switch.
Is the switch OK ?
YES—Do the troubleshooting for the gauge control
module (see page 2 2 - 2 2 6 ) . •
NO—Replace the brake f l u i d level switch. •
DTC 66: TCS Pressure Sensor (Inside of ABS/
TCS Modulator-Control Unit)
1. C l e a r t h e DTC using the HDS (see page 19-35).
2. Disconnect the HDS f r o m the 16P DLC.
3. Turn the ignition switch OFF, then t u r n it ON (II)
again.
4. Test-drive the vehicle.
Does the ABS indicator come on, and is DTC 66
indicated?
Y E S — G o t o step 5.
NO—The system is OK at this t i m e . •
5. Do the TCS pressure sensor neutral position
memorization (see page 19-78).
6. Clear the DTC using the HDS (see page 19-35).
7. Disconnect the HDS f r o m the 16P DLC.
8. Turn the ignition switch OFF, then turn it ON (II)
again.
9. Test-drive the vehicle.
Does the ABS indicator come on, and is DTC 66
indicated?
YES—Check for loose t e r m i n a l s in the ABS/TCS
control unit 47P connector. If no loose terminals are
f o u n d , replace the ABS/TCS modulator-control unit
(see page 19-79). •
NO—The system is OK at this t i m e . •
19-63