Honda ACCORD HYBRID 2005 Service Manual page 1054

Automatic Transmission
A / T C l u t c h P r e s s u r e C o n t r o l S o l e n o i d V a l v e C T e s t
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid C
in Miscellaneous Test M e n u on the HDS.
3. Test the A/T clutch pressure control solenoid valve
C w i t h the HDS.
• If the valve tests OK, the test is complete.
Disconnect the HDS.
• If the valve does not test OK, f o l l o w the
instructions on the HDS.
• If the valve does not test OK, and the HDS does
not determine the cause, go to step 4.
4. Remove the intake air duct and air cleaner housing.
5. Disconnect the A/T clutch pressure control solenoid
valve C connector.
6. Measure the A/T clutch pressure control solenoid
valve C resistance at the connector terminals.
Standard: 3—10 Q
• If the resistance is out of standard, replace the
A/T clutch pressure control solenoid valve C
(see page 14-221).
• If the resistance is w i t h i n the standard, go to step
7.
7. Connect the negative battery terminal to the
solenoid valve C connector t e r m i n a l No. 2, and
connect the positive battery t e r m i n a l to the
connector terminal No. 1.
• If a clicking sound is heard, the valve is OK.
Reconnect the connector, and install all r e m o v e d
parts.
• If no clicking sound is heard, go to step 8.
14-218