Honda ACCORD HYBRID 2005 Service Manual page 1173

C l u t c h C l e a r a n c e I n s p e c t i o n
Special Tools Required
Clutch compressor attachment 07ZAE-PRP0100
1. Inspect the clutch piston, discs, plates, and end
plate for wear and damage (see page 14-335), and
inspect the clutch waved-plate phase difference
(see page 14-336), if necessary.
2. Install the 1st-hold clutch piston in the 1st clutch
piston, and install 1st/1st-hold clutch piston (A) in
the 1st/1st-hold clutch d r u m (B). Do not install the
O-rings on the clutch pistons during inspection.
3. Starting w i t h the 1st-hold clutch plate, alternately
install the plates (A) (3) and discs (B) (3), then install
the 1st-hold clutch plate B (C) w i t h the flat side
d o w n in the direction s h o w n .
4. Measure the 1st-hold clutch plate B-to-top-disc
clearance w i t h a feeler gauge (A) w h i l e pressing the
1st-hold clutch plate B d o w n . Take measurements
in at least three places, and use the average as the
actual clearance.
Ist-hold Clutch Plate B-to-Top-Disc Clearance
Service Limit: 0.6—1.0 mm (0.024—0.039 in.)
5. If the clearance is out of standard, replace the Ist-
hold clutch plates and discs as a set, and recheck.
(cont'd)
14-337