Honda ACCORD HYBRID 2005 Service Manual page 655

15. Measure voltage between PCM connector terminal
C13 and body g r o u n d .
PCM C O N N E C T O R C (22P)
1
1 2
3 4 5 6 7
8 9 10 11 12 13 14 15
16 17 18 19 20 21 22
V C C 2 ( Y E L / B L U )
W i r e side of female t e r m i n a l s
Is there about 5 V?
Y E S — R e p a i r open in the w i r e between the PCM
(C13) and the FTP sensor, then go to step 22.
N O — G o t o step 28.
16. Turn the ignition switch OFF.
17. J u m p the SCS line w i t h the HDS.
18. Disconnect PCM connector E (31P).
19. Check for continuity between FTP sensor 3P
connector terminal No. 2 and body g r o u n d .
FTP S E N S O R 3P C O N N E C T O R
FTP (LT GRN)
W i r e side of female t e r m i n a l s
Is there continuity?
Y E S — R e p a i r short in the w i r e between the PCM
(E29) and the FTP sensor, then go to step 22.
NO—Go to step 28.
20. Turn the ignition switch OFF.
2 1 . Replace the FTP sensor (see page 11-436).
22. Reconnect all connectors.
23. T u r n the ignition switch ON (II).
24. Reset the PCM w i t h the HDS.
25. Do the PCM idle learn procedure (see page 11-340).
26. Check for T e m p o r a r y DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P0452 is indicated, check for poor
connections or loose terminals at the FTP sensor
and the PCM, then go to step 1. If any other
T e m p o r a r y DTCs or DTCs are indicated, go to the
indicated D T C s t r o u b l e s h o o t i n g .
N O — G o t o s t e p 2 7 .
27. M o n i t o r the OBD STATUS for DTC P0452 in the
DTCs M E N U w i t h the HDS.
Does the screen indicate PASSED?
Y E S — T r o u b l e s h o o t i n g is complete. •
NO—If the screen indicates FAILED, check for poor
connections or loose t e r m i n a l s at the FTP sensor
and the PCM, then go to step 1. If the screen
indicates NOT COMPLETED, go to step 25 and
recheck.
(cont'd)
11-415