Honda ACCORD HYBRID 2005 Service Manual page 531

11. Check for continuity between engine mount control
unit 20P connector terminals No. 9 (No. 1)* and
No. 20 (No. 10)*.
ENGINE MOUNT C O N T R O L UNIT 20P CONNECTOR
S O L R M
(GRN)*
S O L F M
(YEL/GRN)
1 2 3 4
i—i
5 6
/
8 9
10 11 12
/
14 15 16 17
/ /
20
SOLRP
(LT B L U ) *
S O L F P
(BLU)
Wire side of female t e r m i n a l s
Is there continuity?
YES—Repair short in the wire between the engine
m o u n t control unit No. 9 and No. 20 terminals
(No. 1 and No. 10 terminals)*, then go to step 14.
N O - G o t o step 12.
12. Measure resistance between front (rear)* active
control engine m o u n t (ACM) actuator 2P connector
terminals No. 1 and No. 2.
ACTIVE C O N T R O L ENGINE MOUNT (ACM)
A C T U A T O R 2P CONNECTOR
1 2
Terminal side of male t e r m i n a l s
Is there about 0.75- 1.15 Q?
YES—Replace the engine m o u n t control unit
(see page 11-323), then go to step 14.
NO—Replace the front engine m o u n t (see page
5-22), or rear engine m o u n t (see page 5-24), then
go to step 14.
(cont'd)
11-291