Honda ACCORD HYBRID 2005 Service Manual page 1154

Shafts and Clutches
S e c o n d a r y S h a f t 1 s t G e a r C l e a r a n c e I n s p e c t i o n
Special Tools Required
• Driver, 40 m m I.D. 07746-0030100
• Attachment, 30 m m I.D. 07746-0030300
1. Install the idler gear (A), thrust needle bearing (B),
1st gear collar (C), needle bearing (D), 1st gear
assembly (E), thrust needle bearing (F), 52 m m
washer (G), and 1st/1st-hold clutch (H) on the
secondary shaft (I). Do not install the O-rings during
inspection.
2. Install the ball bearing (J) over the 1st/1st-hold
clutch guide w i t h the special tools and a press.
07746-0030100
07746-0030300
3. Install the splined washer (K) w i t h the marked side
(L) up over the ball bearing in the same manner as
installing the ball bearing w i t h the special tool and
a press.
4. Install the old lock nut (M) and tighten it to 29 N-m
(3.0 kgf-m, 22 Ibf-ft).
5. Set the dial indicator (A) on the 1st gear (B).
14-318