Honda ACCORD HYBRID 2005 Service Manual page 684

IMA System
G e n e r a l T r o u b l e s h o o t i n g I n f o r m a t i o n
Reset the MCM with the HDS
1. Turn the ignition switch ON (II). Do not start the
engine.
2. Use the HDS to clear the DTC.
NOTE: For specific operations, refer to the user's
manual that came w i t h the HDS.
How to End a Troubleshooting Session
(required after any troubleshooting)
1. Reset the M C M as described above.
2. T u r n the ignition switch OFF.
3. Disconnect the HDS f r o m the DLC.
4. If the I M A battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
5. Do the PCM idle learn procedure (see page 11-340).
( c o n t ' d )
Motor Rotor Position Calibration
Do the motor rotor position calibration w h e n e v e r y o u
do any of these actions:
• The M C M is replaced.
• The motor rotor position sensor is replaced.
• The IMA motor is replaced.
• The motor stator is replaced.
• The engine assembly is replaced.
• The transmission is replaced.
1. Connect the HDS to the data link connector (DLC)
(A) located under the driver's side of the dashboard.
2. Turn the ignition switch ON (II).
3. Select IMA SYSTEM on the HDS.
4. Select the MOTOR ROTOR POSITION
CALIBRATION in the A D J U S T M E N T MENU of the
HDS.
5. Turn the ignition switch OFF, and disconnect the
HDS f r o m the DLC.
12-6