Honda ACCORD HYBRID 2005 Service Manual page 1099

<s*3>
24. Place the shift lever in the R position, then insert a
6.0 m m (0.24 in.) pin (A) t h r o u g h the positioning
hole (B) on the shift lever bracket base, t h r o u g h the
positioning hole on the shift lever, and into the
positioning hole on the shift lever bracket base. The
shift lever is secured in the R position.
B A
25. A l i g n the socket holder (A) on the shift cable (B)
w i t h the slot in the bracket base (C), then slide the
holder into the base. Install the shift cable end (D)
over the m o u n t i n g stud (E) by aligning its square
hole (F) w i t h the square fitting (G) at the b o t t o m of
the stud. Push the holder until it snaps securely in
place. Do not install the shift cable by holding the
shift cable guide (H) and damper (I).
26. Verify that the shift cable end (A) is properly
installed on the m o u n t i n g stud (B).
Properly Installed:
A B
Improperly Installed:
Cable end rides on the b o t t o m of the m o u n t i n g s t u d .
(cont'd)
14-263